An EStop alarm is given on startup of Masso. Press and release the EStop button to test the EStop is working and this will cancel the alarm.
EStop also occurs if the EStop button is pressed on the machine.
This alarm indicates that the machine has not been homed. To clear the alarm home the machine.
If you get a homing error alarm it means something has gone wrong while homing. Rehome the machine to clear
This alarm indicates that the cabinet door is open. Close the door to clear the alarm.
You can set the machine to automatically stop and start when the door is opened or closed.
If you have a G2 you must assign an output as a door alarm even if you do not have a door. Setting this to logic low will remove the alarm
The extremes of travel of each axis is defined in each axis settings page.
If you execute a move that will exceed the limit of travel a soft limit will alarm will dispay.
To cancel issue a valid move on the axis and the alarm will clear.
These alarms are triggered by the homing sensors. If a mechanical fault occurs that causes the axis to trigger a hard limit the Hard Limit alarm will be displayed.
To clear the alarm find and clear the issue that caused the Hard limit alarm and Home the machine to clear the alarm.
A Probing alarm occurs during a probing cycle where Masso does not receive a signal from the probing sensor within the specified distance.
You will also get a probing alarm if the probe is already in the active state when a probing cycle is started.
To clear issue a new probing command with a valid distance ensuring the probe is not already in an active state.
This occurs if you try and load a tool not supported by Masso. EG the tool number is greater that 99 0n the G3 or Greater that 31 on the G2
When a Stepper or Servo drive goes into an alarm condition the Drive can signal Masso which will put the system into Feedhold and stop the spindle.
The Drive alarm indication will be displayed on the screen. you drive must be capable of providing the required signal and they be connected to Masso.
To clear the alarm first clear the fault with the drive and home the machine to clear Alarm indication on Masso.
If you have a lubricant vessel that has an alarm output you can connect it to Masso and a Lubrication alarm will display on Masso.
Top up your lubricant vessel and the alarm will automatically clear.