This command is used to switched OFF any of the 16 auxiliary outputs. If this command is used between motion commands then the motion will come to full stop before switching OFF the output.

Syntax & Parameters

• M65
• P Value - The P value is required and defines the output number to switch On. This value can be between 1 to 16.

Prerequsites

• An output must be configured as an Auxiliary output where the P value is the Auxiliary number. In this example P1
• Auxiliary outputs 1 to 6 can have Auxiliary toggle inputs assigned to toggle them on and off with the press of a button. eg
• Auxiliary outputs 7 to 16 can only be changed through Gcode.

Example program

N10 M65 P1
N20 M65 P4

• The N10 line will switch OFF the auxiliary output 1.
• The N20 line will switch OFF the auxiliary output 4.