MASSO Documentation

M98 & M99 – Sub Program Call

MASSO supports Sub-Program Call using M98 & M99 codes. Subprograms with upto 5 levels of nesting is supported, with this feature sub programs can be called from the main program without the need to rewrite the same program again and again.

When a sub program is called, MASSO looks for a separate ".nc" file and runs that as a sub-program. Having a separate file approach means that programs that have common features can now be used used with other programs.

INFORMATION: All sub-program files must be on the root folder of the USB Flash drive.

INFORMATION: Subroutine toolpaths are not drawn on the screen during program load.

M98 Sub-Program Call

Syntax & Parameters

  • M98
  • P Value - The P value is used to define the sub program file name.
  • L Value - The L value can be used to run the sub program multiple times.

Example program

N10 M98 P10 L5

The above program will look for the file as set by the P value and will run it 5 times as set by L value.

NOTE: If the file is not found an error message on the screen is displayed and program goes into feedhold. When a program is loaded from F6 screen, MASSO checks that all sub-program files are on the USB and if a file is missing an error is shown to the user

M99 End Sub-Program or Return

M99 command is used to End Sub-Program or Return back to the main program.

Syntax & Parameters

  • M99

Example program

N10 M99

When the above line is found in a sub program file, the control returns back to the main program.