MASSO Documentation

Tool Setter / Touch Plate

A tool setter or a simple touch plate can be wired to MASSO to be used with interactive part probing or with G38.2 probing cycle gcode command.


INFORMATION: For information about interactive part probing CLICK HERE


INFORMATION: For information about using G38.2 probing cycle CLICK HERE


Wiring example of a simple touch plate




Assigning the probe input


Once the probe has been wired to one of the MASSO inputs, go to the F1 - Setup screen and assign the input as Probe Input Signal.


CAUTION: The input status must show LOW when the probe is not touched and should only show HIGH when triggered.


INFORMATION: To invert the input signal, invert by selecting the input in the INPUTS list and press the space-bar key on the keyboard. These settings are automatically saved.