Supported G-codes

Shop Support Forum PDF

Documentation

Supported G-codes

G-codes and other program words supported by MASSO. Select a code below for its syntax, parameters and examples.

Supported M-codes

Here are the articles in this section:

G00 - Rapid Motion

G01 - Linear Interpolation Motion

G02 – Circular Interpolation (Clockwise)

G03 – Circular Interpolation (Counter Clockwise)

G04 – Dwell

G10 – Set Work Offset Values

G17 – XY Plane Selection

G18 – ZX Plane Selection

G19 – YZ Plane Selection

G20 – Set Machine Units To Inches

G21 – Set Machine Units To Millimetres

G28 – Return To Machine Home

G30 - Move to Parking Position

G32 – Threading Cycle

G38.2 – Straight Probe Cycle

G38.6 - Digitizing Probing Cycle

G38.7 - Center Probing Cycle

G40 - Cutter Compensation Off

G41- Cutter Compensation Left

G42- Cutter Compensation Right

G53 – Move In Absolute Machine Coordinates

G54 to G59 – Select Work Offset Coordinate System

G54.1 - Extended Work Offsets

G68 – Toolpath Rotation

G69 - Cancel Toolpath Rotation

G73 – High Speed Peck Drilling

G80 – Cancel Modal Motion

G81 – Drilling Cycle

G82 – Drilling Canned Cycle With Dwell

G83 – Peck Drilling For Deeper Holes

G90 – Set Distance Mode To Absolute

G91 – Set Distance Mode To Incremental

G92 – Temporary Work Offset

G92.1 – Cancel Temporary Work Offset

G93 – Inverse Time Mode

G94 – Units Per Minute Mode

G95 - Feed Per Revolution

G96 – Turn on Constant Surface Speed (CSS)

G97 – Turn off Constant Surface Speed (CSS)

G98 – Canned Cycle – Retract Back To The Initial Z

G99 – Canned Cycle – Retract Back To R Plane

G200 - Plasma Parameters

G200 - Laser Parameters

T - Tool Number

MSG - Message command for screen and remote alerts

F - Feed rate

N - Number

S - Speed / Intensity

( ) - Comments

Invalid Gcode

Back

Save & Load Settings

G00 - Rapid Motion

Last Updated On 03 October, 2026