MASSO Documentation

G92 – Temporary Work Offset

This command is used set temporary work offset values. The temporary work offsets are used in combination to the main work offsets G54 to G59.

Syntax & Parameters

  • G92 followed by axis values.
  • X, Y, Z, A, B Value - specifies the axis you wish to move following the distance to move. The distance value will be the current machine units in use.

Example program

N10 G92 X10 Y20

INFORMATION: Units are defined as either inches or mm depending on your machines setup or G20 or G21 command in use.

INFORMATION: When A G92 work offset is used and a DRO is zeroed the offset value will show on the DRO instead of 0. Use G92.1 to clear the temporary work offset.

INFORMATION: G92 work offsets can be cancelled by using G92.1 in Gcode or using MDI