INFORMATION: From MASSO software version 3.47, to use M62 command please use M64 command as M62 command has been changed.
INFORMATION: MASSO G2 does not support M62 command from version 3.47, please use M64.
This command is used to switched ON any of the 16 auxiliary outputs synchronized with the start of the next motion command.
CAUTION: If no motion is commanded, the output will not turn ON. It is best to specify motion immediately following the M62 command.
Syntax & Parameters
- P Value - The P value is required and defines the output number to switch On. This value can be between 1 to 16.
N10 G0 X0 N20 M62 P1 N30 X10 N40 M63 P1 N50 X20
- In the above example the the X axis moves to X0 position, then auxiliary output 1 is turned ON when the X axis starts to move towards X10 position. Once the axis reaches X10 position and starts moving to X20 position, the auxiliary output 1 is turned OFF.
INFORMATION: For M62 P# to work you must assign an output as an auxiliary output in F1-Setup screen under OUTPUTS list.