This command is used to switched ON any of the 16 auxiliary outputs. If this command is used between motion commands then the motion will come to full stop before switching ON the output.
Syntax & Parameters
- P Value - The P value is required and defines the output number to switch On. This value can be between 1 to 16.
N10 M64 P1 N20 M64 P4
- The N10 line will switch ON the auxiliary output 1.
- The N20 line will switch ON the auxiliary output 4.
INFORMATION: For M64 P# to work you must assign an output as an auxiliary output in F1-Setup screen under OUTPUTS list.